Appendix J Emergency Shift for Stern Drive Engines Manual Shift Operation In case of loss of shift at the Control Head, go to the Actuator and switch it into Manual Shift Operation: 1. Unplug the power connector. This will keep the servo from driving the motor and the unit from flashing an “error” on the Control Head. 2. Push lever “A” in the direction of the arrow; this will place the Actuator in “Manual” mode. 3. Turn the bracket style lever “B” clockwise to put the shift into “Forward” or turn it counter-clockwise to shift it into “Reverse.” Warning: Engage lever “B” instructions with caution - they are sometimes reverse of the label.
CANBus Connection Fuse NMEA 2000 ® 12 Volt (3 Pin) Power Connection Electronic Control System: Single Engine Installation Manual for BY Series Engines with Unlimited Controls © Yanmar 2008 Page 73