. OPERATION MACHINE OPERATIONS AND CONTROLS Check Oil Level in Engine Oil Pan, Add Oil WARNING Parts and oil are at high temperature immediately after the engine is stopped and may cause serious burns. Wait for the oil Remove inspection cover (1), then operate drain valve (P) from the inspection window. 3 - 61 temperature to go down b efore performing this operation. 1. Open the engine h 2. Remove dipstick ( G), and wipe the oil off with a clot 3. Fully insert dipstick (G) into filler pipe (F), then r emo 4. The oil level should be between the H and L marks o n dipstick (G). If the oil level is be low the L mark, add oil through oi l filler (F). 5.
If the oil is above t he H mark, drain the e xcessive engin e oil from drain plug (P check the oil level ) at the bottom of the engine oil pan, then again. 6. If oil level is correc t, securely tighten the o il fille r cap and REMARK When checking the oil l evel after the engine ha s bee n operated , wait for at least 15 minu tes after stopping the engine before checking. angle, make it horizontal before checking. I f the machine is at an angle, make it horizont al before c hecking.