Komatsu — BEFORE STARTING ENGINE

. OPERATION MACHINE OPERATIONS AND CONTROLS Check Oil Level in Hydraulic Tank, Add Oil WARNING and may cause burns. Wait for the Check Working Lamp Switch Turn the lamp switch to the ON position and check that the working lamp light up. 3 - 64 The parts and oil are at high temperature immediately temperature to go dow n before starting the work. When removing the oil filler cap, turn it slowly to release the internal pressure, th 1. Set the work equip ment in the posture shown in the diagram on the right, then chec k the oil level and add oil if ne cessary. hown in the ngine at low 2.

If the work equipm diagram on the rig speed, retract the lower the boom, set and stop the engin ent is not in the condition s ht, start the engine, run the e arm and bucket cylinder rod the bucket teeth in contact with s fully, then the ground, e. s after stopping the engine, move each 3. Within 15 second control lever (for w in all directions to r ork equipment and travel) to th e full stroke elease the internal pressure. 4. Check sight gauge (G). The oil level should be be tween the H and L marks. NOTICE Do not add oil above the H line. This will damage the hydra ulic circuit or cause the oil to spurt out.

If oil has been added to above the H level, stop the engine and wait for the hydraulic oil to cool down, then dr ain the excess oil from drain plug (P). 5. If the level is below the L mark, add oil through oil fi ller (F) at the top of the hydraulic tank. REMARK The oil level will vary d epending upon the oil tempera Accordingly, use the fo llowing as a guide: Before starting oper ation: Between H and L levels (Oil temperature 10 to 30°C (50 to 86°F)) Around H level to 80°C (122 to 176°F)) Normal operation: (Oil temperature 50 I f t he lamps do not lig ht up, there is probably a bro ken bulb or disconnection in the w repairs. iring, contact your Komatsu distributor for