Komatsu — WORK EQUIPMENT CONTROLS AND OPERATIONS

. OPERATION MACHINE OPERATIONS AND CONTROLS WORK EQUIPMENT CONTROLS AND OPERATIONS WARNING equipment is held in that engine speed to a engine stopped, it is 3 - 91 If t he le ver is operated wh en the eng ine speed has been lowe red by the auto-deceleration function, the en rise, op erate the levers c Use th e contro l levers to operat e the wo rk equipmen Note t eleased, positio The wo rk equipment is operated by the le ft and right w ork equipment control levers.

The left w lever o perates the arm and swi ng, and t he right work equipment control lever operates the b The m ovemen ts of th e lever an d work e quipment are as shown in the diagrams on the right releas ed, they automatically ret urn to th e neutral pos ition and the work equipment is held in If th e work e quipme nt control levers ar e returned to the neutral position when the machine i fuel control dial is peed.

set to FULL, the auto-deceleration mechanism will act to reduce th auto-deceler mid-range s REMAR With th is machine, an accumula tor is ins talled in the o perating circuit, if less than 15 seconds engine was st opped, when the starting switch is tur ned to t he ON position even with the ground. possib le to operate th e levers t o lower w ork equipme nt to the In addition, this opera tion can a lso be us ed to releas e the remaining pressure in the hydrauli lower t he boom after t he machi ne has b een loaded o Arm o peration Swing operatio