Komatsu — BUCKET REPLACEMENT AND INVERSION

. OPERATION MACHINE OPERATIONS AND CONTROLS Inversion NOTICE 1. Place the bucket in contact with a flat surface. 2. Remove the double nut on the stopper bolt for arm pin (A) and link pin (B), remove the bolt, pull out arm pin (A) and link pin (B), and then remove the bucket. 3. After removing the bucket, reverse it. 4. Align arm (5) with replacement bucket hole (1), then align link (6) with hole (2), coat pins (A) and (B) with grease, and install. 5. Install the stopper bolts and nuts for each pin, then grease the pin. 3 - 105 The rock bucket (PC 400: if equipp ed, PC 450:

standard) interferes with the arm, so it cannot be reversed to c REMARK When removing the pins, pla contact with the ground. ce the bucket so that it is in light If the bucket is lowered stron gly to the ground, the resistance will be increased and it will be diff icult to remove the pins. NOTICE After removing the pins, make sur e that mud or sand does not get on them. Dust seals are fitted at both ends o f the bushings, be careful not to damage them. When reversing, do not install an O-ring. Keep the O-ring in a safe place until using it next. REMARK Lubricate with grease thor from the end face.

oughly until the grease comes out When replacing the bucket , replace the dust seal if it has been damaged. If a damaged s sand and dirt may enter t wear of the pin. eal is used without being replaced, he pin portion and cause abnormal