. OPERATION TRANSPORTATION bending. display GG. switches OFF J ON J OFF in turn. When auto-deceleration switch (1) is turned OFF, monitor display GG (2) goes out. 3 - 116 Unloading 1. Load and u nload on firm level ground on ly. Maintain a safe distance from the edge of a ro 2. Apply the tr ailer brakes securely, then pu t blocks (1) under the tires to prev ent the trailer from moving. Set left and right ramps (2) paralle paced to the left and right of c enter (3) of the trailer. gle of installation (4) a ma ximum of 15°. If the r the weight of the end a large amount unde , put blocks under the ramps to prevent them from 3. Remove th e chains and wire ropes faste 4.
Start the en Warm the e 5. Set the lock 6. Set the trav el speed selector switch to L o (low speed travel). Press tr speed. T avel speed selector switch he travel speed (Lo, Mi, Hi) is (1) to set the travel displayed on monitor 7. Turn auto-d eceleration switch (1) OFF and operate the fuel w idle. (1) is pressed, it control dial Each tim to set the engine speed to lo e auto-deceleration switch