Komatsu — LIFTING MACHINE

. OPERATION TRANSPORTATION LIFTING MACHINE WARNING installed on the machine. For the proper lifting 3 - 118 The operator car rying out the lifting oper ation using a cran e must be a properly qualified crane op Never raise the m achine with any worker Always make sur e that the wire rope is o f ample strength fo r the weight of t When lifting, kee p the machine horizonta When carrying ou t lifting operations, set t he lock lever to the LOCK position t o prevent the machine f rom moving unexpectedly. Never enter the a rea under or around a r aised machine.

Never try to lift the machine in any posture other than the post ure given in the procedure below or us ing lifting equipment other than in the procedu re below. at the machine may lose its balance. There is a hazard th at the machine may lose NOTICE e applies to machines with standard specifications. The lifting procedur e applies to machines w ith standard speci The method of lifti ng differs according to attachments and options actually or. procedures, contac t your Komatsu distribut For details of the weight, see "SPECIFICATIONS (PAG E 5-2)". t ground as follows. When lifting the m achine, carry out the operation on fla t ground as 1.

Start the engine, then the swing the upper structure so that the work equipment will be on the side of sprocket (1). 2. Extend the bucket cylinder and arm cylinder fully, then lower the work equipment to the ground as shown in the diagram on the right using the boom cylinder. 1. Start the engi ne, then the swing the upper structure so that the work equipment will be on the side of sprocket pment to the ground a s shown in the d 3. Set the lock l ever securely to the L OCK position (L) 4. Stop the engi ne, check that there i s nothing around the operator's compartment, then get off the machin Close the cab door and front glass securely.