Komatsu — DISCHARGED BATTERY

. OPERATION TROUBLES AND ACTIONS DISCHARGED BATTERY WARNING turn the rubber the chassis, should be 3 - 133 It is dan gerous to cha rge a battery when mounted on a machi sure th at it is dismou nted before chargin g. stop the engine and When c hecking or ha ndling the battery, starting The bat switch key to tery generates the OFF position. hydrogen gas, so there is a hazard of e Do not bring lighted c igarettes near the b attery, or do anything cause s parks. Battery electrolyte is d ilute sulphuric acid , and it will attack you and ski n. If it gets on your clothes or on your skin, immediatel off with a large amou nt of water.

If it gets in your eyes, wash it fresh w ater and cons When h gloves. When r emoving the b attery, first disconn ect the cable from th (normal ly the negative (-) terminal) (diagr am A). When installin the pos itive (+) termin al first (diagram B) . If a tool touches betw een at the positive (+) terminal and the there is danger that it will cause a spark, so be extremely care If the te rminals are loo se, there is danger that the defective con generat e sparks that will cause an explosion. Terminals s connec ted firmly. When r emoving or ins talling the terminal s, check which is the (+) term inal and whic h is the negative (-) terminal.

Battery Removal and Installation e the ground cable (normally connected to the negative (-) terminal). Before removing th e battery, remov e the ground cable (normally connect ed to the negative (-) terminal). If any t ool touches between the posi tive terminal and th e chassis , there is a hazard of spar ks being generated. When installing the battery, connect the ground cable l ast. down. .7 N·m (1 to 1.5 kgf·m, 7.2 to 10.8 lbft) When replacing the battery, secure i t with battery hold- Tighte ning torque:Tightening battery terminal: 9.8 to 14 .7 N·m (1 to 1.5 kg f·m, 7.2 to 10.8 l