. OPERATION TROUBLES AND ACTIONS Machine Monitoring System (*): For details of handling the emergency pump drive switch and swing holding brake cancel switch, see "SWITCHES (PAGE 3-17)". 3 - 141 Electronic Control System If an error code appears on the machine monitor display (normally displays TIME), follow the countermeasure table as shown below in the self-diagnosis. Monitor display Error mode Countermeasure E02 PC-EPC valve system error If the pump override switch is set to the ON position, operation can be carried out. However, immediately have the TVC valve system inspected by your Komatsu distributor.(*) E03 Swing brake system error Turn the swing prolix switch ON to cancel the brake.
When applying the swing brake, operate the swing lock switch manually. Depending on the cause of the failure, it may be impossible to release the brake. In any case, have the system inspected immediately by your Komatsu distributor.(*) E05 Governor system error Governor will not execute the control function. Manually operate the governor-lever. To fix the governor lever at the full stroke position, use the retaining bolt holes on bracket. In this case, immediately have the governor system inspected by your Komatsu distributor. When no error code is displayed and starting motor rotates, but engine does not start Turn emergency fuel solenoid drive switch ON and turn starting switch to START.
If engine starts, release emergency fuel solenoid drive switch and return it to OFF position. The switch will return automatically to the OFF position when it is released. In the case where the monitor will not display error codes and work equipment operation and swing operation cannot be carried out. Have the machine inspected immediately by your Komatsu distributor.