. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE entering. 4 - 20 NOTICE Never remo ve the inner eleme nt (6). It will allow dirt t o enter and cause failure of th e engine. her tool. D o not use a screwdriver or ot 3. After rem oving the outer e lement (5), cover th e inner element (6) with from 4. Wipe off or brush off the di rt stuck to cover (3) a nd the inside of the air cl 5. Remove any dirt or dust th at is accumulated to evacuator valve (4) instal 6.
Direct dr y compressed air (less than 0.69 MPa (7 kgf/cm2, 99.4 PSI)) to direct it f 1) Rem has 2) Repl time inne PSI)) to the outer eleme nt from inside along its folds, then direct it f rom outside alon g its folds and again from insid e. 1) Rem ove one seal from the element whene ver the element been cleaned. ace the outer el ement which has been cleaned 6 2) Repl s repeatedly or u sed throughout a year. Replace the ame time. r element at the s