Komatsu — CLEAN AND INSPECT RADIATOR FINS, OIL COOLER FINS, AFTERCOOLER FINS, FUEL COOLER FINS, AND AIR CONDITIONER CONDENSER FINS (ONLY MACHINES EQUIPPED WITH AIR CONDITIONER)

. MAINTENANCE MAINTENANCE PROCEDURE CLEAN AND INSPECT RADIATOR FINS, OIL COOLER FINS, AFTERCOOLER FINS, FUEL COOLER FINS, AND AIR CONDITIONER CONDENSER FINS (only machines equipped with air conditioner) WARNING NOTICE 4 - 61 f compressed air, high-pressur e water, or steam hit your body d irectly, or they cause dirt or dust to be blown up, there is a hazard f serious injury. Always use s afety glasses, dust mask, or oth When using compressed air for cleaning, blow it keeping some d istance to avoid damaging the fins. Da mage on the fins can cause water leakage and overheating. In a dusty job site, check the fin s every day, regardless of the mainten 1. Open the engine hood. pull up net (2).

e installed again, as instructed in the over (3) on the engine side, then slide 2. Loosen screw (1), then 3. Clean net (2). (it is to b step 8.) Loosen bolts (4) of top c cover (3) to the rear. 4. 5. Check the front face and fins (6), aftercooler fins rear face of oil cooler fins (5), radiator (7), condenser fins (8), and fuel cooler fins (9). If there are a compressed air. ny leaves, mud, or dirt, blow off with used instead of compressed air. Steam or water may be used instead of compressed 6. Check the rubber hose. Replace with a new one if th e hose is found to have cracks or check the hose clamps to be hardened by aging. In addition, for looseness. 7.

Remove undercovers ( 10) and (11), and clean o ut all t he leaves, mud, and dirt bl own off during the cleaning o peration. 8. Insert cleaned net (2) in to its original position, then in stall with screw (1). unting bolts (4). and (11). 9. Install cover (3) with mo 10. Install undercovers (10)