. MAINTENANCE MAINTENANCE PROCEDURE 4 - 65 6. When installing, tighten until the packing surface contact s the seal surfac e of t he filter holder, then tighten i t 3/4 of a t urn. If the filter cartridge is ti ghtened too far, the packing will b e damaged and this wil l lead to leakage of fuel. I f the filter c artridge is too loo se, fuel will also lea k from the pa cking, so always tighten the c orrect amount When t ightening with a filter wrench, be extremely car eful not to dent o r damage th e filter. 7. Chec k tha t the drain pl ug at the bottom of t he water sep arator cup is tightened s ecure Tightenin g torque: 0.2 t o 0.45 N·m (0.02 to 0.046 kgf·m, 0.1 to 0.3 lbft) 8.
When carrying out stan dard replacemen t of the fuel filter c artridge (every 1 000 hours), r eplace the cartridge and bleed the air. For detai ls, see "REPLACE FUEL FILTER CARTRIDGE ( PAGE 4-66)" 9. Start the engine, check that there i s no l eakage of fuel fr om the filter seal surfac e or w ater separator mounting surface, t hen run for ap prox. 10 minutes at