. ATTACHMENTS AND OPTIONS MACHINE READY FOR ATTACHMENT Adjusting Oil Flow Depending on the attachment, it is necessary to change the oil flow in the service circuit. For details of setting the oil flow, see "ATTACHMENT OPERATIONS (PAGE 6-13)". Switching Between Breaker and General Attachment If an attachment is installed as an option, and the mode is set to B mode: (1) The system is set to the breaker operation circuit (1-way circuit). (2) The hydraulic oil flowing to the breaker circuit flows to the additional filter for the breaker. (3) The relief pressure valve is set to low pressure. Set pressure when machine is shipped from factory:
17.2 MPa (175 kgf/cm 2 , 2,490 PSI) (4) It is possible to use the selector mode to adjust the maximum oil flow. If an attachment is installed as an option, and the mode is set to A or E mode: (1) The system is set to the crusher operation circuit (2-way circuit). (2) The hydraulic oil flowing to the crusher circuit does not flow to the additional filter for the breaker. (3) The relief pressure valve is set to high pressure. Set pressure when machine is shipped from factory: 20.1 MPa (205 kgf/cm 2 , 2,911 PSI) (4) It is possible to use the selector mode to adjust the maximum oil flow.
6 - 7 HYDRAULIC CIRCUIT NOTICE NOTICE It is ne cessary to return the return c ircuit direct ly to t he retur n filter when a breaker i s used, so use only the B mode . Do not use an y other mode. When the mac hine i s shipp ed from the f actory , the s tandar d set pressure of the sa fety valve in the service valve is set as follow s: B mode is selected: 17.2 MPa (175 kgf/cm2, 2,485 PSI) A or E mode is selected: 20.1 MPa (205 kg/cm2, 2,911 PSI). When B mode is selected: 1 7.2 MPa (175 kgf/cm When A or E m ode is selecte d: 20.1 MPa (205 k g/cm2, 2,911 P SI). The se t pressu re ma y have t o be adjusted depending on the a ttachment.
In such cas es, please ask your Komatsu distributor to carr y out th e adjustment. Switching Hydraulic Circuit Depending o n the type of attachmen t, set the w orking mode on the monitor as follows. The s et pressure o f the sa fety valve in the s ervice valve and the hydraulic circ uit switch is according to the working mode select ed. Attachment Working mode Hydraulic circuit Set pressure of service safety valve 1-way circuit attachment (such as breaker) B mode Return circuit automatically becomes circuit which does not pass through control valve When shipped from factory:
17.2 MPa (175 kgf/cm2, 2,485 PSI) 2-way circuit attachment (such as crusher) A mode or E mode Return circuit automatically becomes circuit which passes through control valve When shipped from factory: 20.1 MPa (205 kgf/cm2, 2,911 PSI)