Komatsu — ATTACHMENT REMOVAL AND INSTALLATION

. ATTACHMENTS AND OPTIONS MACHINE READY FOR ATTACHMENT ATTACHMENT REMOVAL AND INSTALLATION to 6 - 11 Attachment Removal the ground and stop the engine. 1. 2. 3. 1. Lower the attachment to the ground and stop the en gine. 2. Turn the starting switch t o the ON position (B), then s et the lock lever to the FREE positio n (F). equipment control lever and the l back and forth, left and right at full 3. Operate each work attachment control peda stroke 2 to 3 times to e hydraulic circuit. ght a t full liminate the internal pressure in the 4. Loosen slowly oil filler c ap (F) on top of the hydrau eliminate the internal pre ssure in the hydraulic circu 5.

After checking that the o il has cooled down, turn th e roto r on the stop valve installed to the piping for the inlet port and o utlet port on the side face of t he arm to the LOCK positio n (L). 6. Remove the hoses on th e attachment side. Install th e plu gs to the two outlets. The plugs are used to p revent the attachment from incorrect operation caused by mixi ng in of foreign matter. After the p lugs are correctly installed, st ore the attachment.