. MULTI-MONITOR SPECIFICATION MACHINE OPERATIONS AND CONTROLS In Cold Weather Areas 7 - 41 (AUTOMATI C WARMING-U P OPERATIO This machin e is equipped wit h an automa tic warming-up When the en gine is started, if the engine co olant temperat ure is low (below 30 °C (86 °F)), the warming-up operation is carried out automatically. tic warming-up The automa temperature (30 °C (86 °F)) or if the wa rming-up oper ation is continued for 10 minut es. If the engine coolant temperature further as fol NOTICE Do not sudd enly accelerate the engine before the warming-up operation is complete Do not run t minutes. T d.
he engine at low or high idle continuously for more than 20 his will cause oil leaks from the turbocharger oil supply piping. If it i to time or r Never perf s necessary to run un the engine at a orm operations o the engine at mid-range spe r operate the idle, apply a load from time ed. control levers when the hydraulic oi operation u l is still a low temp ntil the hydraulic erature. Alway oil temperatur s continue the w e monitor display arming-up is green. This will ex tend the service lif e of the machi ne. REMARK If the hydrau lic oil temperatur e is low, the hydraulic oil te mperatur e monitor display will b 1.
Turn fuel control dial (2) t o the low idl e (MIN) positio n and run the engin monitor g e under no load until the eng ine coolant tem perature ives a green dis play. oil temperature quickly, use the n the machine monitor to set to A ion mode). 2. To raise the hydraulic mode switch o oil temper operating mode (h n the mach eavy-duty operat ion mode). 3. Turn fuel control dial (2) t o the mediu m speed positio