Komatsu — AFTER STARTING ENGINE

. MULTI-MONITOR SPECIFICATION MACHINE OPERATIONS AND CONTROLS MULTI-MONITOR SPECIFICATION MACHINE OPERATIONS AND CONTROLS If REPLACE AIR CLEANER 7 - 43 7. After the warming-up ope ration is completed, check that ea gauge and monitor lamp Radiator coolant level Engine oil level monito Charge level monitor ( Fuel level monitor (10) Engine coolant tempe Engine oil pressure m Engine coolant tempe Fuel gauge (14): Indic Engine pre-heating m Air cleaner clogging m Hydraulic oil temperat Hydraulic oil temperat gauge and monitor lamp Radiator coolant level is in the following condition: monitor (7): OFF r (8): OFF 9): OFF :

Green display Engine oil level monito Charge level monitor ( Fuel level monitor (10) Engine coolant tempe Engine oil pressure m rature monitor (11): Green display onitor (12): OFF rature gauge (13): Indicator in bla range ator in black range onitor (15): OFF onitor (16): OFF ure gauge (17): Indicator in bla range ure monitor (18): Green display Engine coolant tempe rature gauge (13): Indicato Hydraulic oil temperat ure monitor (18): Green di Engine pre-heating m Air cleaner clogging m Hydraulic oil temperat 8. Check for abnormal exh aust gas color, noise, or v ibration any problem is found, co ntact your Komatsu distributor. 9.

If air cleaner clogging mo nitor (16) lights up, clean or replac e the element immedi For details of the metho d of cleaning the element, see "CHECK, CLEAN AND ". ELEMENT (PAGE 4-19) 10. Turn fuel control dial (2) to the full speed (MAX) p osition a . carry out the operation is Step 5. for 3 to 5 minutes 11. Repeat the following ope ration 3 - 5 times and oper ate slow Boom operation RA ISE ←→ LOWER ←→ OUT RL ←→ DUMP FT ←→ RIGHT Arm operation IN Bucket operation CU Swing operation LE Travel (Lo) operation F ORWARD ←→ REVERSE REMARK f the above operation is not carried out, then may be a delay i n respons e when starti ng or stopping the actuation of the travel, swing, or work equipment. 12.

Use working mode select or switch (19) on machine monitor to select the working mo de to be used.