Komatsu — ATTACHMENTS AND OPTIONS

. MULTI-MONITOR SPECIFICATION MAINTENANCE PROCEDURE MULTI-MONITOR SPECIFICATION MAINTENANCE PROCEDURE 7 - 55 NOTICE Never remo ve the inner eleme nt (6). It will allow dirt to e nter and cause failure of th e engine. her tool. D o not use a screwdriver or ot 3. After rem oving the outer e lement (5), cover the inner element (6) with a clean cloth or tape to prevent dirt or dust from from entering. 4. Wipe off or brush off the di rt stuck to cove r (3) an d the inside of the air cl 5. Remove any dirt or dust th at is accumulated to ev acuator valve (4) instal 6.

Direct dr y compressed air (less than 0.69 MPa (7 kgf/cm2, 99.4 PSI)) to direct it f 1) Rem has 2) Repl time inne PSI)) to the outer eleme nt from inside along i ts folds, then direct it f rom outside alon g its folds and again fr om insid e. 1) Rem ove one seal from the element w henev er the element been cleaned. ace the outer el ement which has been cleaned 6 2) Repl s repeatedly or u sed throughou r element at the s