Komatsu — ATTACHMENTS AND OPTIONS

. MULTI-MONITOR SPECIFICATION MAINTENANCE PROCEDURE Install Air Cleaner Element air 7 - 57 NOTIC Do not use any damaged gasket or seal or element with damaged pleats Cleaning the element or O-ring aft er one year has passed and using them again will cause problems. Always r eplace them with new parts. The seal portion on imitation part s lacks precision, and allows the e ntry of dus t, which lea ds to damage of th e engine. D o not use such imitation parts. Do not run the engine with the in ner element removed. It will caus e damage to the engin 1. C heck that there is no dirt or oil stuck to the seal portion of the new e lement or cleaned element . Wipe of f any rt or oil. 2.

W hen the outer element has been removed, check that th e inn er element has not com e out of position a nd is t at an angle. If inner elem ent is at an angle, insert your hand and push it in straight. 3. P ush the outer element in st raight with your hand when installin g it t o the air c leaner the outer element is held a nd rocked lightly up and down and to the left and r ight while pushing it in, the outer ement can be inserted eas NOTIC E When i nserting the element, if the r ubber at the tip is swollen or the outer element is not pushed in straight, and cover (3) is assembled by force to hook (2), th assembling.

ere is danger that the hook and air cleaner body may be damaged, so be careful when leaner when 4. In stall cover (3) as follows. 1 2 3 4 5 ) Align cover (3) with the e ) Hook the tip of hook (2 cleaner body and lock it ) When locking hooks (2) i n position, apply the hooks in t on opposite sides (top, b as when tightening bolts ottom, left, right) in the same ) Always install cover (3) the ground (A). ) When cover (3) is inst between the air cleaner b If it is too large, install ag