Komatsu — MONITORING SYSTEM

. OPERATION DETAILED CONTROLS AND GAUGES Gauges and Meter 3 - 12 Swing Lock Monitor rms the operator that the swing lock is being ck switch is turned ON (ACTUATED), the p. lding brake relase switch is turned on, this . This monitor (2) info actuated. Actuated: Lights up When the swing lo monitor lamp lights u When the swing ho monitor lamp flashes REMARK The swing motor is e quipped with a disc brake that mechanically stops the rotation. W hen the swing lock monitor is lighted up, the brake remains applie d. Engine Coolant Temp erature Gauge tes the engine coolant temperature. normal during operation, the green range will light up.

up during operation, the overheat prevention system will be actuated. tion system is actuated as follows. up: Engine coolant temperature monitor lamp (C) flashes. up: Engine speed is reduced to low idling, engine coolant temperature monitor lamp (C) flashes, and alarm buzzer sounds at the same time. ntion system works until the temperature ge.

has lighted up, if the fuel control dial is set to ine coolant temperature drops, the display is This gauge (3) indica tes the engine coolant temper If the temperatuer is normal during operation, the g reen range will light u If the red range lights up during operation, the over heat preventio n syste m will be actuate The overheat preven tion system is actuated as foll Red range (A) lights up: Engine coolant temperatur e monitor lamp (C) flashes. up: Engine speed is reduced to low idling, Red range (B) lights The overheat preve engine coolant temperature monitor lamp (C) flashes, and alarm buzzer sounds at the same time. ntion system works until the temperature ge.

e monitor lamp enters the green ran When red range (A) has lighted up, if the fuel contr ol dial is set to low idle after the eng ine coolant temperature drops , the display is canceled. Fuel Gauge This meter (4) shows the fuel level in the fuel tank. During normal operation, the lamp s If the lamp in the red hould light up in the green ran range flashes during operatio ge. n, there is less than 100 liters (24.42 fuel. US gal) of fuel remaining, so check and add Red range (A) lights The correct level ma up: Fuel gauge monitor lamp ( y not be displayed for a short B) flashes. time after the starting switch is tu abnormality.

rned to the ON position, but this is not an When the engine is s topped, turn the starting switch ON and check that each item and th e meters light up.