Scania — Oil pressure

Engine Tier-3 710655- Ch 1 page 116 Oil pressure Max. oil pressure: Warm engine running at a speed above 800 rpm 6 bar High lubricating oil pressure (above 6 bar) is normal when starting a cold engine. Normal oil pressure: Warm engine running at an operating speed of 3 - 6 bar Min. oil pressure: warm engine running at a speed of 1000 rpm 1.0 bar The control system has the following alarm levels: - at a speed of less than 1000 rpm and an oil pressure of less than 1.0 bar - at a speed of more than 1000 rpm and an oil pressure of less than 2.3 bar for longer than 5 seconds. The following functions are available if there is an alarm:

- Alarm which only switches on the warning lamp and diagnostics lamp. A fault code is generated in the control unit. After an alarm, approved values should be registered for more than 1 second to reset the alarm. The pistons are cooled by the lubrication oil. Oil is sprayed up under the piston crown through special nozzles, one for each cylinder. Since piston cooling is not needed at low engine rpm, an oil pressure valve in the oil cooler hous­ ing opens at 3 bar. See the next page. SHOP MANUAL MT26-31 - 06.2005