Scania — Dismantling and assembly

Engine Tier-3 710655- Ch 1 page 123 6. Grasp the rotor bowl and tap lightly with your hand or carefully use a screwdriver between the rotor bowl and the strainer so that the rotor bowl comes loose from the rotor. Note: Never strike on the rotor directly as this may damage its bearings. 6. Remove the rotor nut and bowl from the rotor. 7. Remove the strainer located on the rotor. If the strainer has fastened, prise carefully with a knife or screwdriver at the bottom between the rotor and the strainer. 8. Scrape away the deposits inside the bowl with a knife. 9. Wash the parts. 10. Inspect the two nozzles on the rotor. Make sure they are not blocked or damaged.

Renew with new rotor if any damaged on the nozzles. 11. Make sure the bearings are not damaged. Renew with new rotor if any damaged on the bearing SHOP MANUAL MT26-31 - 06.2005