Engine Tier-3 710655- Ch 1 page 134 Removing 1. Drain the cooling system through the drain taps in the block and in the pipe from the outlet on the radiator. 2. Remove any protection meshes and fan ring with sealing ring to gain access to the fan. 3. Remove the fan. 4. Turn the automatic belt tensioner and prise the poly-V-belt off the coolant pump pulley. 5. Remove the coolant pump assembly. Fitting the pump 1. Clean old gasket debris from the sealing surfaces. 2. Fit the pump without damaging the seal(s). 3. Fit the automatic belt tensioner. 1. Front cover 2. Gasket 3. Pump cover 4. Shaft with bearing 5. Sealing ring 6. Impeller 7. Pulley 8. Guide sleeve 9. Flange screw 10. Flange screw 4.
Fit the (poly-V) drive belt and any protection mesh and fan ring with sealing ring. 5. Fit the fan. 6. Fill the cooling system. See booklet 00:03-01 for the composition of the coolant. 7. Start the engine and check that no leakage occurs. Check the level of the coolant and top up as necessary. SHOP MANUAL MT26-31 - 06.2005