Scania — Measuring radial clearance and axial clearance

Engine Tier-3 710655- Ch 1 page 70 Measuring radial clearance and axial clearance Measuring radial clearance and axial clearance does no usually give any indication of the remaining service life of the turbocharger. When the turbocharger is not working correctly or sounds abnormal, measuring charge pressure or measuring radial clearance or axial clearance can show that the turbocharger is defective. To measure axial and radial clearances it is advis­able to remove the turbocharger and bolt it to a steel plate, which will also serve as a base for the magnetic stand holding the dial gauge. Radial clearance Take readings on both turbine wheel and com­pressor wheel. 1.

Place the tip of the deflektion gauge against the turbine wheel and compressor wheel. 2. Pull both ends of the shaft up. Take a reading. 3. Press both ends of the shaft down. Take a reading. The difference between readings is radial clearance. 4. Repeat measurements three times on each side. Measuring turbine wheel radial clearance with deflection gauge 8222 and measuring stand 8209 5. If any wheel rubs against the housing, despite radial clearance being within toler­ance, the turbocharger should be changed. Measuring compressor wheel radial clearanse with deflection gauge 8222 and measuring stand 8209 SHOP MANUAL MT26-31 - 06.2005