Scania — Renewing the turbocharger

Engine Tier-3 710655- Ch 1 page 72 Renewing the turbocharger Note: When renewing the turbocharger, all gaskets and the oil filter must be changed and the centrifugal cleaner must be cleaned. Removal 1. Detach the delivery and return oil lines from the turbocharger. 2. Detach the exhaust pipe, induction pipe and charge air cooler pipe from the turbocharger. 3. Undo the bolts in the turbocharger base and remove the turbocharger. Fitting 1. Check the connecting flange on the exhaust manifold to ensure that there are no remnants of the old gasket. 2. Fit a new gasket and bolt on a new turbocharger. Lubricate the exhaust manifold bolts with high-temperature resistant lubricant, part No. 561 205.

Tighten the turbocharger to 50 Nm and the exhaust manifold to 59 Nm. 3. Connect the oil supply and return lines. 4. Connect the charge air pipe, induction pipe and exhaust pipe. 5. Disconnect the fuel valve’s power supply (fuel shut-off) and turn the engine over with the starter motor for at least 30 seconds so that the lubricating oil will reach the turbocharger. 6. Start the engine and check that there is no leakage. SHOP MANUAL MT26-31 - 06.2005