Scania — Connecting rods

Engine Tier-3 710655- Ch 1 page 75 Connecting rods The connecting rod and big-end cap consist of a single casting which is split during the machining operation. To prevent the big-end cap from being displaced in relation to the connecting rod, the contact surfaces are provided with grooves and guide pins. The sur­faces are machined together to ensure a precise and accurate fit. The parts are also marked so that they can always be fitted in the same position. The connecting rod and big-end cap are split obliquely, partly so that the con rod bolts will not be subjected to excessive loads and partly to ena­ble the piston and con rod to be withdrawn through the cylinder.

The upper part of the connecting rod is wedge shaped. This al­ lows a larger journal surface on the underside of the gudgeon pin where load is great­est during combustion. SHOP MANUAL MT26-31 - 06.2005