Scania — Removing and dismantling connecting rods and pistons

Engine Tier-3 710655- Ch 1 page 77 Checking connecting rods Check the connecting rods using tool 587 110. Proceed as follows: 1. When the gudgeon pin bushing has been checked, insert the bearing cap as marked and tighten the bolts to full torque. 2. Mount the connecting rod in the tool using the expander and place the gudgeon pin in its bushing. Then place indicator studs on the gudgeon pin. Checking if connecting rod is twisted - Check whether the connecting rod is twisted with the indicator studs horizontal. - Check whether the connecting rod is bent with the indicator studs vertical. - The distance between the indicator studs on the tool illustrated here is 75 mm.

- The distance between one of the indicator studs and the measuring surface must be max. 0.1 mm when measured using this tool. - Check with a feeler gauge. Checking if connecting rod is bent - Also check whether the connecting rod is bent into an Sshape. This is done by measuring the distance between the outside of the connecting rod bushing and the level surface of the tool. - Turn the connecting rod around and measure the corresponding distance. Important! The difference must not exceed 0.6 mm. Checking whether the connecting rod is bent into an S shape SHOP MANUAL MT26-31 - 06.2005