Scania — Removing the flywheel

Engine Tier-3 710655- Ch 1 page 92 Renewing support bearing 1. Remove the retaining rings on both sides of the support bearing. 8410 2. Knock out the support bearing from the flywheel using drift 8410. 3. Fit the inner retaining ring and fit the new support bearing with drift 8410. 4. Fit the outer retaining ring. Renewing ring gear Renew the flywheel ring gear if the gear teeth have become so worn that the starter motor pinion will not engage. 1. Grind a groove as deep as possible in the ring gear and crack it open with a chisel. Remove the ring gear from the flywheel. WARNING! ! Use protective goggles due to the risk of metal shivers. 2.

Clean the contact surfaces on the flywheel with a wire brush. 3. Heat the new ring gear evenly around its circumference to 100 -150°C. 4. Place the heated ring gear on the flywheel so that the marking with the part number is facing the engine when fitting the flywheel. Make sure the ring gear is securely against the flywheel. If necessary, knock down the ring gear with a plastic hammer. 5. The ring gear must not be cooled rapidly but be left to cool in the open air. SHOP MANUAL MT26-31 - 06.2005