Scania — Fitting flywheel housing

Engine Tier-3 710655- Ch 1 page 94 Fitting flywheel housing 1. Remove all old sealing compound on the sealing surfaces of the timing gear casing and timing gear plate. Clean off any oil and grease using an alcohol based cleaning agent. Note: The sealing surfaces must be absolutely clean and free from grease. Do not touch the surfaces after degreasing. 2. Apply the sealing agent (512565) on the timing gear housing with the air powered sprayer (512559), cartridge adapter (512565) and nozzle (512558). The width of the bead should be between 0.8 and 1.2 mm. Follow the pattern as illustrated. Important!

Ensure that you apply sealing agent inside the screwholes, but without allowing sealing agent into the crankcase. The sealing agent may block channels and nozzles. This is particularly important to bear in mind around oil ways, where the flow of oil to the air compressor or injection pump can be blocked. Important! Assembly must be completed within 25 minutes of starting to apply the sealing agent. Note: The bolts are of various sizes and lengths. Ensure that they are fitted in the correct places. See also the illustrations on the next page. 3. Torque tighten the M12 bolts to 90 Nm and the M10 bolts to 50 Nm. 4.

Fit the starter motor Apply the sealing agent on the timing gear housing side against the transmission plate. Apply the sealing agent around the screw holes marked with arrows. SHOP MANUAL MT26-31 - 06.2005