Doosan Infracore D18NAP — P0193 Rail Pressure Sensor high fault

5. Failure Diagnosis P0193 Rail Pressure Sensor high fault 1. Overview 2. Condition for Running Diagnostic During engine running 3. Condition for Setting the Fault Code If the feedback rail pressure of rail pressure sensor is out of the threshold 4. Condition for Clearing the Fault Code If the feedback rail pressure of rail pressure is within the threshold 5.

Inspection Items 5 - 46 Code Causes Impact P0193 Electrical problem Connection problem Sensor problem Abnormally vehicle be pushed CE lamp Flashing Torque Reduction Lv1 Delay engine stop NO ECU Pin Description 1 138 VREF1 Rail Pressure Sensor 2 119 Rail Pressure Sensor Return 3 135 Rail Pressure Sensor Step Inspection Standard Value YES NO 1 P0193 is occurred on diagnostic tool? Step 2 2 After let the machine be in safety area and turn-off the key switch Step 3 3 This fault could be caused by pushing vehicle while engine is off. Vehicle been pushed? Clear fault. Poor detection Step 3 4 VEXT fault present? Step 5 Step 6 5 Problem with one of these sensors causing loss of Vext:

Disconnect sensors one by one checking if fault disappear to find which one is faulty. If None is found faulty, check short circuit and isolation of Vext lines on the harness 6 Check sensor connection Connection problem? Do necessary repair Step 7 7 Check ECU connection Connection problem? Do necessary repair Step 8 8 Check continuity and electrical insulation Electrical problem? Fix harness Step 10 9 Change sensor + rail Problem still present? Call Hot-line