5. Failure Diagnosis P0087 Rail Pressure Sensor fault (pressure build up during cranking too slow) 1. Overview 2. Condition for Running Diagnostic During rail filling 3. Condition for Setting the Fault Code If rail filling time is longer than threshold, fault code is raised. 4. Condition for Clearing the Fault Code If Rail filling time is within the threshold, fault code is cleared. 5. Inspection Items 5 - 48 Code Causes Impact P0087 Faulty IMV (sticking,leaking etc), Faulty rail pressure sensor. (Aged or malfunction) Failure of rail filling LPC(Low pressure circuit)problem.
(leakage, fuel is not supplied due to some reason.) HPC(High pressure circuity)problem.(leakage etc) CE lamp ON NO ECU Pin Description 1 138 VREF1 Rail Pressure Sensor 2 119 Rail Pressure Sensor Return 3 135 Rail Pressure Sensor Step Inspection Standard Value YES NO 1 P0087 is occurred on diagnostic tool? Step 2 2 Fault of type IMV or rail pressure sensor? First, fix the corresponding fault Step 3 3 DTC link to High Pressure control? Step 4 No problem 4 Check that:
* fuel feed circuit is in good condition * there is diesel fuel present in the system * there is no air (no bubbles or emulsion in the pipes) * there is enough fuel pressure in inlet pump * there are no high pressure circuit leaks * there is diesel fuel of the correct quality and type Low pressure circuit faulty? Repair the low pressure circuit Step 5 5 According to engine start or not, different tests are to be done. Does engine start? Step 6 Step 7 6 Perform "DYNAMIC IMV TEST" Faulty IMV? Replace IMV Step 8 7 Perform "STATIC INJECTOR BACKLEAK TEST" Carry out the "tube test: Result? Replace corresponding injector(s) Replace HP pump