Doosan Infracore D18NAP — P0258 RPC error (IMV current trim drift low/low)

5. Failure Diagnosis 2) B 5 - 118 Step Inspection Standard Value YES NO 1 P0258 is occurred on diagnostic tool? Step 2 2 Fault of type IMV or rail pressure sensor? First, fix the corresponding fault Step 3 3 DTC link to High Pressure control? Step 4 No problem 4 Check that: * fuel feed circuit is in good condition * there is diesel fuel present in the system * there is no air (no bubbles or emulsion in the pipes) * there is enough fuel pressure in inlet pump * there are no high pressure circuit leaks * there is diesel fuel of the correct quality and type Low pressure circuit faulty? Repair the low pressure circuit Step 5 5 According to engine start or not, different tests are to be done.

Does engine start? Step 6 Step 7 6 Perform "DYNAMIC IMV TEST" Faulty IMV? Replace IMV Step 8 7 Perform "STATIC INJECTOR BACKLEAK TEST" Carry out the "tube test: Result? Replace corresponding injector(s) Replace HP pump 8 Perform "DYNAMIC INJECTOR BACKLEAK TEST" Backleak above limit? Replace corresponding injector(s) Step 9 9 Perform "PUMP PRESSURE BUILD CAPACITY" This test need specific equipment "hydraulic-T" Result? End Replace HP pump