6. About the engine Engine Disassembly 5) After completing coolant drain, reconnect the coolant drain plug. Special Tools DANGER If the radiator cap is opened while the engine is hot, hot water will spurt out and may cause serious burns. Open the radiator cap after making sure that the engine has been fully cooled. Mark and separately manage the containers for storing coolant from beverage containers to avoid confusion. See a doctor immediately in case of drinking coolant. WARNING Discard coolant according to the regulations set forth by the relevant authorities. Disposing of discharged coolant into the ground, sewers, drains, rivers, or the sea will cause serious environmental pollution.
Violation of regulations when discarding engine oil without observing the handling regulations, will be punished. CAUTION Be careful not to get coolant on any belts or electric apparatus when replacing the coolant. Procedure of Disassembling an Engine 2. Drain the engine oil. 1) Place a container under the engine to drain the CAUTION engine oil. Prepare tools and genuine parts necessary before disassembling engine. 2) Remove the oil cap. Prepare a shelf for the storage of removed parts. 3) Remove the drain plug and drain the engine oil. Perform repairs in a light and clean space. WARNING Keep hands clean while performing repairs.
Keep parts removed from the engine in the order of disassembly. Discard oil according to the regulations set forth by the relevant authorities. Disposing of discharged oil into the ground, sewers, drains, rivers, or the sea will cause serious environmental pollution. Violation of regulations when discarding engine oil without observing the handling regulations, will be punished. Do not allow parts removed from the engine to touch each other or be mixed with other parts. Disassemble the engine in the following order. 1. Drain coolant. 3. Detach the air cooler and cooling fan from engine. 1) Check if the engine and radiator are cooled. 2) Place a container in front of the coolant drain plug.
4. Detach the engine from the machine. 3) Remove the radiator cap. 4) Remove the coolant drain plug of the radiator and then drain coolant. 5. Disconnect the cables and harness connected to each sensor of the engine. 6. Remove the V-belt. 6 - 7 Figure Product Number/Name EF.120-262 Valve Spring Compression Tool T7621010E Piston Ring Plier 850306-00078 Oil seal disassembly jig