Doosan Infracore D18NAP — Procedure of Disassembling an Engine

6. About the engine 45. Remove the crank case. 46. Remove the crankshaft. C D B C A EDL013042A EDL013044A 1) Remove 2 thrust washers (C). 2) Remove the crankshaft (B). 3) Remove 4 upper main bearings (A) from the cylinder block. B 47. Remove the camshaft. A EDL013043A 1) Remove the rear oil seal with oil seal disassembly jig (850306-00078). CAUTION A B Do not reuse the oil seal; replace it with a new one. 2) Loosen 12 collared hex bolts (D). EDL013045A 3) Loosen 8 main bearing cap bolts (C). 2) Remove the camshaft (A). 1) Loosen 2 hex bolts (B). 4) Remove the crank case (B). 5) Loosen 4 lower main bearings (A) from the crank case. 6 - 18