Doosan Infracore D18NAP — Assembly of Exhaust Manifold

10. Intake/Exhaust System 3. Attach the exhaust manifold pipe (Only TYPE-1). 5. Attach the turbocharger. 1 A B C D A B C E EDL013017A EDL013007A 1) Attach the exhaust manifold pipe (A). 2) Tighten 3 flange hex bolts (B) at a tightening 2 torque of 4.4 kgf m. 3) Tighten 3 hex nuts (C) at a tightening torque of 2.2 kgf m. Note) The exhaust mainfold pipe (A) is only TYPE-1. A B 4. Attach the EGR cooler assembly and the cam C position sensor. D EDL013008A A 1) Attach the gasket and the turbocharger(A). B 2) Tighten 4 flange hex bolts (B) at a tightening C 3) Connect the oil delivery pipe (C). torque of 2.2 kgf•m.

E 4) Tighten 2 hollow screws from the oil delivery pipe D at a tightening torque of 2.0 kgf•m. Note) Tighten the fixing bolt (D) if the engine is TYPE-1. EDL013015A 5) Connect the oil return pipe. 1) Attach the EGR cooler assembly (A). Note) The oil return pipe is that TYPE-1 is (E) and TYPE-2 is (D). CAUTION CAUTION Be careful to note the direction when mounting the EGR cooler. Be careful to note the direction when connecting the hose and gasket. Be careful not to damage the gasket while mounting it. Do not reuse the hose clamps but replace them with new ones. Do not reuse the oil delivery pipe but replace it with new one.

2) Tighten 3 flange hex bolts (B) at a tightening torque of 3.1 kgf m. 3) Connect the rubber hoses (C) 4) Attach the cam position sensor (D). 5) Tighten the fixing bolt(E). 10 - 20