Doosan Infracore D18NAP — Assembly of Cylinder Head

11. Cylinder block/head Cylinder head 4. Check flatness of the cylinder head. Disassembly of Cylinder Head Note)Refer to Chapter 6 (Procedure of Disassembling an Engine) 1. Detach the cylinder head. Check of Cylinder Head 1. Remove carbon from the bottom surface of the cylinder head. Note)Be careful not to scratch the valve seat surface. 2. For cracks or damage which cannot be checked with naked eye, perform the hydrostatic test or the EDL013088A magnetic particle testing. 3. Check if the cylinder head is warped. 1) Measure flatness of the intake assembly surface and the exhaust assembly surface of the cylinder D F B head with the scale and the gap gauge. C E 5. Perform the hydrostatic test.

1) Block the discharging outlets of the cooling water A path and the oil path of the cylinder head and put pressure of 4 kg/cm 2 on the inlet. Then sink the cylinder head in the 70 °C water for 1 minute and check if air leaks. Assembly of Cylinder Head EDL013087A 1. Attach the cylinder head. 1) Check 6 directions from A to F with the scale and Note)Refer to Chapter 6 (Procedure of Assembling an Engine) the gap gauge. 11 - 10