Doosan Infracore D18NAP — Connection of Glow Plug

12. Electric System Air Heater Disconnection of Glow Plug 1. Remove the common rail and the injection pipes. Connection of Glow Plug 1. Attach the glow plug. C C A D A B B E D EDL013006A EDL013021A 1) Loosen the fixing bolt (E). 2) Loosen the nuts of the fuel injection pipes. 1) Tightening 3 glow plugs (A) to the cylinder head at a tightening torque of 9~12 N m. 2) Attach the electric connector (B). 3) Remove 4 fuel injection pipes (C) and (D). 3) Attach 3 washers (C). 4) Tighten 3 hex nuts (D) at a tightening torque of 2.5~3 N m. CAUTION Do not reuse fuel injection pipes; replace them with new ones.

If fuel injection pipes are reused it may allow foreign substances into the fuel pipes or cause oil leaks from bolt clamping and cause a critical fault in engine performance. 2. Attach the common rail and the injection pipe. 4) Loosen 2 collared hex bolts (B) of the common rail. 5) Remove the common rail (A) from the intake manifold. C A 2. Remove the glow plug. B E C A D D B EDL013006A 1) Attach the common rail (A) to the intake manifold. CAUTION Be careful to note the direction when attching the common rail. Be careful not to damage the common rail while attaching it. EDL013021A 1) Loosen 3 hex nuts (D) and remove 3 washers (C).

2) Remove the electric connector (B) and 3 glow 2) Temporarily tighten 2 collared hex bolts (B) by plugs (A). hand. 12 - 9