13. Others/Driving System Others/Driving System General Information Therefore, like a piston, the connecting rod can be disassembled through the upper side of the cylinder. An alloy-type prefabricated bearing is used for the active part of the crankshaft and the connecting rod. General Information 1. The forged crankshaft is an integral structure. The crankshaft and the rear oil seals prevent oil from 2. The connecting rod is forged and its large end part permeating into the flywheel housing. 3. The camshaft, oil pump, and high-pressure injection pump are driven by gear connection in is vertically separated. the timing gear case.
Specifications 13 - 3 Item D18NAP Remark DL01-LEE00 DL01-LEL00 Other/Driving System Piston outside diameter Grade A: 89.920 ~ 89.930mm Grade B:
89.930 ~ 89.940mm ← Gap between cylinder and piston 0.060 ~ 0.080 mm ← Piston ring groove area Top ring groove 1.915 ~ 1.945 mm ← 2nd ring groove 2.060 ~ 2.080 mm ← Oil ring groove 3.020 ~ 3.040 mm ← Piston ring side gap Top ring side gap 0.083 ~ 0.133 mm ← 2dn ring side gap 0.070 ~ 0.110 mm ← Oil ring side gap 0.030 ~ 0.070 mm ← Piston ring end gap Top ring end gap 0.20 ~ 0.30 mm ← 2nd ring end gap 0.55 ~ 0.70 mm ← Oil ring end gap 0.2 ~ 0.4 mm ← Piston pin outside diameter 30.995 ~ 31,000 mm ← Piston pin hole bore 31.008 ~ 31.014 mm ← Piston pin hole gap 0.008 ~ 0.019 mm ← Connecting rod small-end bore 31.025 ~ 31.038 mm ← Connecting rod small-end hole gap 0.025 ~ 0.043 mm ← Connecting rod large-end bore 57.000 ~ 57.015 mm ←