5. Failure Diagnosis P046D EGR actuator position feedback signal noisy fault 1. Overview 2. Condition for Running Diagnostic Key on or engine run 3. Condition for Setting the Fault Code There is not EGR sensor fault and there is a noise spike on the sensor signal. (Noise detect: If the absolute difference, comparing the raw actual position to low pass filtered position value, exceeds calibration value (4.6V). 4. Condition for Clearing the Fault Code The noise spike is restored. 5.
Check Items 5 - 16 Code Causes Impact P046D Electrical problem Connection problem Sensor problem CE lamp ON Torque Reduction Lv0 NO ECU Pin Description 1 193 EGR (H-Bridge Neg) 2 164 EGR, VREF3 3 - Not used 4 172 EGR Sensor Return GND 5 192 EGR (H-Bridge Pos) 6 116 EGR Position Sensor Signal Step Inspection Standard Value YES NO 1 P046D is occurred on diagnostic tool? Step 2 2 After let the machine be in safety area and turn-off the key switch Step 3 3 Check air inlet circuit:
* Valve state * Depression circuit * Vacuum value pump * Open solenoid valve * Vanne state * Air inlet valve functionality Step 4 4 Check connection of the valve Check that the supply voltage is correct Check that the valve position can reach MIN to MAX position (0% to 100%) If applicable, launch a learning of EGR position Problem of connection / supply / position? Do necessary repair Problem solved