. OPERATION EXPLANATION OF COMPONENTS METHOD OF OPERATION When carrying out the defrosting, if the temperature control switch is set so that all lamps are red, this will improve the performance for defrosting and demisting. With the FACE vents, it is possible to adjust the direction of the air flow and to turn it on or off. However, do not set to the FACE mode with the vents closed. WHEN NOT USING THE AIR CONDITIONER REGURARLY To lubricate each part of the compressor, operate cooling, dehumidifying and heating for 3 to 5 minutes once a month at low idle. Also, check the amount of cooling gas twice a year. REMARK If the temperature inside the cab is low, the air conditioner may not work.
In such cases, use the recirculated air to warm up the inside of the cab, then turn the air conditioner switch on. The air conditioner will be run. PRECAUTIONS WHEN USING AIR CONDITIONER Carry out ventilation from time to time when using the cooling. If you smoke when using the air conditioner in the RECIRC mode, your eyes may start to itch or burn. Ventilate the cab ever so often to remove the smoke. When using the air conditioner for a long period of time, carry out ventilation process at least once every hour. Be careful not to cool the cab too much.
When using the air conditioner, it is recommended for health reasons, that it should only feel slightly cooler (5 or 6 ° C (9 or 10.8 ° F) lower than the outside temperature) when you enter the cab. Therefore, adjust the temperature to a suitable level.
3 - 67 Switch Condition of use Fan switch Air conditioner switch Temperature control switch RECIRC/FRESH selector switch Mode selector switch Cooling Rapid HI ON All green RECIRC FACE Normal HI - LO ON More than half are green FRESH FACE Dehumidifying, heating HI - LO ON More than half are red FRESH FOOT Heating Rapid HI OFF All red RECIRC FOOT Normal HI - LO OFF More than half are red FRESH FOOT Defroster HI ON More than half are red FRESH DEF Vetilation or pressurizing HI - LO OFF All green FRESH FACE