Komatsu — METHOD OF TOWING MACHINE

. OPERATION TROUBLESHOOTING 3 - 124 This machine must not be towed ex cept in emergencies. When towing the machine, ta ke the following p recautions. When towing a machine, tow it at a low speed of less than 2 km/h (1.2 MPH), and f or a distance of a few meters to a place where repairs can be c arried out. The machine should be towed only in emergencies. If t he machine must be moved long distances, u se a transporter. e class as the machine being towed. Use a towing machine of the sam Check that the towing machine h as ample braking power, weight, and rimpull to allo w it to control bot h machines on slopes or on the tow road.

When towing, set the articulate lo ck of the towed machine to the LOCK position. Ho wever, when towi ng in places where it is needed to steer, set th e articulate lock to the FREE position. Use two t owing machines of the same class or larger than the machine being towed. being towed: connect one machine each to the front and rear of the machine he towing machine and the machine being towed. Use the specified hook for both t he towing machine and the machine being towed To protect the operator if the towi ng wire or towing bar breaks, install protective plate s on both the towi ng machine and the machine being towed.

There are towing hooks under th e front frame and at the rear of the rear frame. Use only these hooks when ce for towing. ck the condition of the hook to make sure that there is no abnormality. e as small as possible. ter lines of the two machines to within 30 degrees. r various differing conditions, so it is impossible to determine beforehand the will require the minimum rimpull, while towing on slopes or on uneven road m rimpull. towing.

Do not use any other pla When fitting the towing wire, che ck the condition of the hook to make sure that the re is no abnorma Keep the angle of the towing wir Keep the angle between the cen ter lines of the two machines to within 30 degrees Towing may be carried out unde requirements for towing. Towing on flat horizontal roads surfaces will require the maximu If the pressure in a hydraulic circ uit has dropped because of leakage of oil, the par king brake will be applied, so release the parking brake before towing.

e, always put blocks under all t blocked, there is danger that rawbar, and remove the blocks led machine is in a condition brake, check first that the ed, the brakes cannot be used, on is safe. e two towing machines. One disabled machine and should a drawbar to pull the disabled The other machine should tow Before releasing the parking brak four wheels. If the wheels are no the machine may move. Connect with the towing wire or d from the wheels when the disab where it cannot run away. When releasing the parking surrounding area is safe.

When the parking brake is releas so check carefully that the situati When towing down a slope, us machine should be uphill from the be connected with towing wire or machine back and keep it stable. the disabled machine downhill.