Komatsu — OUTLINE OF ELECTRIC SYSTEM

. MAINTENANCE OUTLINE OF SERVICE STORING OIL AND FUEL oldest oil or fuel first). 4 - 7 Keep indoors to prevent any water, dirt, or other i When keeping drum cans for a long period, put the drum on its side so that the filler port of the drums is at the side to prevent moisture from being sucked in. If d rums have to be stored outside, cover them wi th a waterproof sheet or take other measures to protect t hem. To prevent any change in quality during long-term storage, be sure to use in the order of first in - first out (us e the FILTERS Filters are extremely important safety parts. The important equipment and causing problems. Replace all filters periodically.

For details, see the However, when working in severe conditions, repl (sulfur content) being used. y prevent impurities in the fuel and air circuits from entering Operation and Maintenance Manual. Replace all filters periodically. For details, see the However, when working in severe conditions, repl ace the filters at shorter intervals according to the oil an d fuel (sulfur content) being used. se them again. Always replace with new filters. Never try to clean the filters (cartridge type) and u When replacing oil filters, check if any metal particl es are attached to the old filter. If any metal particles are fo und, contact your Komatsu distributor.

er with the specified clean oil, then install it. they are to be used. When replacing the engine oil filter, fill the new filt Do not open packs of spare filters until just before Always use Komatsu genuine filters. OUTLINE OF ELECTRIC SYSTEM It i s extremely dangerous if the electrical equipme nt becomes wet or the covering of the wiring is damaged. This wil l cause an electrical short circuit and may lead to malfunction of the machine. Do not wash the inside o f the operator's cab with water. When washing the components.

machine, be careful not to let water get into the electrical Service relating to the electric system is checking fan belt tension, checking damage or wear to the fan bel t and checking battery fluid level. hose specified by Komatsu. se malfunction of the control system controller, so before ent, contact your Komatsu distributor. e electric system to prevent corrosion.

Never install any electric components other than t External electro-magnetic interference may cau installing a radio receiver or other wireless equipm When working at the seashore, carefully clean th When installing an operator's cab cooler or any o ther electrical equipment, connect it to an independent p ower source connector. The cables to supply power to the optional equipment must never be connected to the fuse, starting switch, or battery relay.