. MAINTENANCE PERIODIC REPLACEMENT OF SAFETY CRITICAL PARTS SAFETY CRITICAL PARTS 4 - 15 PERIODIC REPLACEMENT OF SAFETY CRITICAL PARTS To en sure saf ety at all times when operating or driving the m achine, th e user of the machine mu st alw ays carry out period ic maintenance. In ad dition, to further improve safety, the parts in the safety-critical parts li st on t he next page must also be replaced at th e specified inter val. These par ts are part icularly c losely connected to safety and fire fire prevention, so please conta ct your Komatsu distributor to h ave them r eplaced.
Mater ial qualit y of these pa rts can change a s time passes a nd they ar e likely t o wear out or deteriora te. However, it is di fficult to determine the extent of wear o r deterioration a t the time o f periodi c maintenance. H ence , it is required to rep lace the m with new o nes regardless of their conditio n after a c l times. ertain period of usage. This is important to ensur e that th ese parts mai ntain their full pe rformance at al Furthermore, should anythin g abnormal be fo und on any of t hese parts, replace it with a new one even if the periodic replacement ti me for the pa rt has not yet arr ived.
If any of the h ose clamps s how deterioration like deformatio n or crack ing, repl ace the clamps a t the same time as the ho ses. perform t he following checks with hydraulic hoses which need to be replaced periodically. Tighten all loose place defective hoses, as required. g hoses, always replace O-rings, gaskets, and other such parts at the same time. Also clamp s and re place defecti ve hoses, as req When replacin g hoses, alw ays replace O-rin gs, gaskets, an d other su ch parts at the same time No.
Safety critical parts for periodic replacement R eplacement interval Remarks 1 Fuel hose (fuel tank - injection pump) Fuel hose (injection pump - fuel tank) Spill hose (engine output connector - fuel tank) Water separator (case, O-ring, plug) Rubber hose for brake piping High-pressure hose in steering oil pressure circuit (pump ←→ demand valve ←→ steering valve ←→ steering cylinder) High-pressure hose in hoist circuit (pump ←→ demand valve ←→ hoist valve ←→ hoist cylinder) Every 4000 hours or 2 years, whichever comes sooner 2 3 4 5 6 7 Hose at discharge side of retarder cooling pump 9 Hose at discharge side of transmission pump Every 2000 hours or 1 year, whichever comes sooner 10 High-pressure hose in brake control circuit (pump ←→ accumulator charge valve ←→ accumulator) Brake valve parts Parking brake valve parts Accumulator charge valve parts Retarder control valve parts Parking brake chamber parts Slack adjuster parts 11 Replace as service kit 12 13 14 15 16 17 Seat belt Every 3 years Replace