. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE 5 CHECK LEVEL OF WINDOW WASHER FLUID, ADD FLUID window washer tank (1), and if it is When operating at below freezing point, use fluid with antifreeze. 4 - 26 3. Remove the grill from the fra me end at the front of the machine, he bottom of the radiator and drain ose drain valve (3) and fill with city rt the engine, and run it at low idle. low idle for 10 minutes until the more than 90°C (194°F). valve (3) and drain the water. After an the cooling system with cleaning agent. e the instructions for the cleaning agent. lve (3), and drain all the water. or, then set valve (1) to the OPEN position to open it.
stor, see "REPLACE CORROSION RESISTOR CARTRIDGE (PAGE 4-56)". freeze until it overflows from the water filler. then open drain valve (3) at t he bottom of the radiator and the coolant. 4. After draining the coolant, cl ose drain valve (3) and fill with water. 5. When the radiator is full, sta rt the engine, and run it at low Keep the engine running at water temperature reaches 6. Stop the engine, open drain valve (3) and drain the water. draining the water, close it. 7. After draining the water, cle an the cooling system with cl For the cleaning method, se 8. After flushing, open drain va lve (3), and drain all the wate 9. Close drain valve (3). 10.
Replace the corrosion resist or, then set valve (1) to the O PEN position to op For replacing corrosion resi stor, see "REPLACE CORROSION RESISTOR CARTRIDGE (P 11. Add coolant mixed with anti freeze until it overflows from t he water filler. Decide the proportions of an tifreeze and water according t o the table for the m ixing rate of wat er and antifre 12. To remove the air containe d in the coolant, run the eng ine at low idle for 5 filler cap OFF.) minutes, then run for anoth minutes at high idle. (When doing this, leave the coolant 13. Stop the engine. About 3 m inutes later, supply the coola nt up to the coolant filler, then close radiator cap 14.
Drain the coolant from inside subtank (4), flush the inside o subtank, then fill with the co olant to a point between the F Carry out this check if there is a ir in the window washer fluid. Check the level of the fluid in w low, fill with automobile window Be careful not to let dirt or dust