Komatsu — SELECTION AND INSPECTION OF TIRES

. MAINTENANCE SERVICE PROCEDURE CHECK OF INFLATION PRESSURE OF TIRES AND INFLATION OF THEM WARNING Tire size Inflation pressure [MPa (kgf/cm 2 , PSI)] 26.5-R25 VLT (standard) 0.44 (4.5, 63.9) 26.5-R25 VKT (standard) 26.5-R25 XADT (standard) 26.5-R25 RL2+ (standard) 800/65 R29 (if equipped) 0.39 (4.0, 56.8) NOTICE If the tires are used when the inflation pressure is less than the value given in the table above, the rim may be damaged. Always keep the tire inflation pressure within +0 to +0.03 MPa (0.3 kgf/cm 2 , 4.3 PSI) of the value in the table above.

4 - 33 When inflati ng a tire, check th at any person will not enter the working area and use an air chuck whic h has a clip and which can be fix ed to the air valve. While inflati ng the tire, check th e inflation pre ssure occasional ly so that it will not ris e too high. If the rim is n ot fitted normally, it may be brok en and scattered while the tire is inflate d. Accordingly, pl ace a guard a round the tire an d do not work in fron t of the rim but wo rk on the tread side of the tire. f the rim Abnormal d rop of inflation pr essure and ab normal fitting o rim indicate a tr ouble in the tire o r rim. In this c ase, be sure to ask a tire repair shop for repair.

bserve the specified inflation pressure. st the inflation pressure of the tires just after high-speed vy-load work. Be sure to o bserve the specifie d inflation pre Do not adju st the inflation pre travel or hea vy-load work. Check Measure the i nflation pressure with a tire p ressure gauge , while the tires are cool, before s Inflation of tires ation pressure properly. Adjust the infl ation pressure p When inflatin g a tire, use an a ir chuck whic h can be fixed to the air valve of the tire as sho wn in the figure. Do not work in front of the rim but wo rk on the trea d side of the ti The proper in flation pressure i s shown belo