. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE REPLACE CORROSION RESISTOR CARTRIDGE WARNING Filter wrench 4 - 56 9. Loosen the knob of priming pump (3), then pump the knob and rom air bleed plug (2). 8 N·m (0.8 to 1 kgf·m, 5.9 to 7.2 lbft) e supply pump. prox. 90 to 100 times) until no more uel from air bleeder (4), then tighten 9 N·m (0.5 to 0.7 kgf·m, 3.6 to 5.1 ing pump (3) becomes stiff. ump (3) in and tighten it. check that fuel comes out f 10. Tighten air bleed plug (2). Tightening torque: 7.8 to 9. 11. Loosen air bleeder (4) of th 12. Pump priming pump (3) (ap bubbles come out with the f air bleeder (4). Tightening torque: 4.9 to 6. lbft) 13.
Continue pumping until prim 14. Push the knob of priming p 15. After replacing the filter cart ridge, start the engine and check for leakage of oil from t he filter seal surface. If any oil leakage is found, check the filter cartridge, then che found, replace the cartridge the tightening of the filter cartridge. If oil still leaks, repe at Steps 1 and 2 to remove ck the packing surface for damage or embedded foreign material. If any problem is with a new part, then repeat Steps 3-15 to install the n ew cartridge. All the engine parts are at high tem perature after the engine has been operated, so never replace t he cartridge immediately after finishing operations. replacing the cartridge.
Wait for the oil to cool down before 1. Set valve (1) at the top of th position, to close it. 2. Set the container to catch t e corrosion resistor to the CLOSED he water under the cartridge. ve cartridge (2). the steel surface of the new filter oil, then install it. ntil the gasket contacts the seal hen tighten a further 2/3 turns. tened too far, the gasket will be o leakage of water. If the filter is too m the gap at the gasket, so always position to open it. e, start the engine and check that there is no leakage of water from the filter seal age of water, check the tightening of the filter cartridge. 3. Using a filter wrench, remo 4.
Clean the filter holder, coat cartridge with clean engine 5. When installing, tighten u surface of the filter holder, t If the filter cartridge is tigh damaged and this will lead t loose, water will also leak fro tighten the correct amount. 6. Set valve (1) to the OPEN 7. After replacing the cartridg surface. If there is any leak age of water, check the tightening o f the filter cartridge.