. OPERATION EXPLANATION OF COMPONENTS GEAR SHIFT LEVER The gear range can be selected with this lever (3) to match the travel conditions. dump body, set the dump lever to the 5 - 1 position: 3 - 41 ACCELERATO This pedal (2) i s used to adjust the engine It can be opera ted freely between the engi ne low idle positio n and the full throttle D position: r normal travel. placed in this position, the transmission is shifted rom 2nd torque converter drive to 6th speed to el speed of the machine. dy is raised, the shift lever is fixed at 2nd. Always p body when traveling. speed in this position is 57.1km/h (35.5 MPH).
This is used fo If the lever is automatically f match the trav el speed of the machine. If the dump bo dy is raised, the shift lever lower the dum p body when traveling. The maximum speed in this position is 57 .1km/h (35.5 MPH Position R1: This is used w hen traveling in reverse. W hen this position is used , the transmission is fixed in R1 and the trav el is carried out in to rque converter drive or dire ct drive according to the trave l speed. The maxim um travel s peed in this position is 7.2 km/h (4.5 MPH). Position R2: This is used w hen traveling in reverse.
W hen this position is used , the transmission is fixed in R2 and the trav el is carried out in to rque converter drive or dire ct drive according to the trave l speed. The maxim um travel s peed in this position is 17.0 km/h (10.6 MPH). It is impossible to travel in reverse if the dump body is rais ed. L ower the "FLOAT" positi on, then set the gearshift le ver to the "R1" or "R2" position. These position s are used in places where it is difficult to tra vel at high speed, or when trave ling on sof t groun d, or when starting t he machine off on a slope when it is loaded. They are a lso used when going do wnhill if it is needed to use the braking force of the