SERVICE MOWER 6. Remove spring locking pin and washer (H) and front draft rod (I) from mower deck bracket (J). 2. Put lift lever in the transport position. 3. Slide mower under machine. 7. Remove mower drive belt from drive sheave (K). 4. Put wood blocks under each side of mower deck. Service Mower - 41 G F F MX10516 5. Remove spring locking pins and washers (F) and disconnect rear draft arms (G), two on each side. L M MX10514 • On 42 (3 in 1) only: Push PTO drive cable into clip (L) MX10516 5. Remove spring locking pins and washers (F) and disconnect rear draft arms (G), two on each side. • On c C d m • e • b AUTION: Avoid injury! Rotating blades are angerous.
Before adjusting or servicing ower: Disconnect spark plug wire(s) to prevent ngine from starting accidently. Always wear gloves when handling mower lades or working near blades. 8. Remove wood blocks from both sides and slide m out from under the machine. 9. When operating the machine without the mower d • Remove rear draft arms and front draft rod from tractor and attach them to the mower deck. ower 5. Put lift lever in lowest position. eck: A B B MX10516 6. Fasten rear draft arms (A), two on each side, with washers and spring locking pins (B).