SERVICE ELECTRICAL Using Booster Battery 4. Connect the other end (F) of negative (–) booster cable to a metal part of the disabled machine frame away from battery. 5. Start the engine of the disabled machine and run machine for several minutes. 6. Carefully disconnect the booster cables in the exact reverse order: negative cable first and then the positive cable. Replacing Headlight Bulb 1. Park machine safely. (See Parking Safely in the SAFETY section.) MIF TS204 2. Lift hood. A 3. Turn bulb socket (A) 1/4 turn counterclockwise to remove. MX10504 4. Replace defective bulb with a new bulb. 5. Insert bulb socket into housing, push in and turn 1/4 turn clockwise to install. 6. Lower hood.
Replacing Fuse 1. Park machine safely. (See Parking Safely in the SAFETY section.) M71044 2. Lift hood. A - Booster Battery B - Disabled Vehicle Battery 1. Connect positive (+) booster cable to booster battery (A) positive (+) post (C). 2. Connect the other end of positive (+) booster cable to the disabled vehicle battery (B) positive (+) post (D). 3. Connect negative (–) booster cable to booster battery negative (–) post (E). Service Electrical - 48 c CAUTION: Avoid injury! The battery produces a flammable and explosive gas. The battery may explode: • Do not attempt to jump start a frozen battery. Warm to 16 degrees C (60 degrees F). • Do not smoke near battery.
• Wear eye protection and gloves. • Keep sparks and flames away. • Do not connect the negative (-) booster cable to the negative (-) terminal of the discharged battery. Connect at a good ground location away from the discharged battery. a y y. d F C E D B A F C E D B A