03-M-E3B, 03-M-DI-E3B, 03-M-E3BG WSM DIESEL ENGINE Fuel Tightness of Pump Element [D1803-M-DI, V2403-M-DI, V2403-M-DI-T] 1. Remove the solenoid. 2. Remove the injection pipes and glow plugs. 3. Install the injection pump pressure tester to the injection pump. 4. Install the injection nozzle (2) jetted with the proper injection pressure to the injection pump pressure tester (1). (Refer to the figure.) 5. Set the speed control lever to the maximum speed position. 6. Run the starter to increase the pressure. 7. If the pressure can not reach the allowable limit, replace the pump with new one or repair with a Kubota-authorized pump service shop.
NOTE Q Never try to disassemble the injection pump assembly. For repairs, you are strongly requested to contact a Kubota- authorized pump service shop. (1) Injection Pump Pressure Tester (2) Injection Nozzle (3) Protection Cover for Jetted Fuel W1104546 S-30 KiSC issued 07, 2008 A Fuel tightness of pump element Allowable limit 18.63 MPa 190.0 kgf/cm2 2702 psi