03-M-E3B, 03-M-DI-E3B, 03-M-E3BG WSM DIESEL ENGINE (7) Electronic Governor Speed Sensor 1. Disconnect the speed sensor connector (2) (3P). 2. Check the state of the harness and if it is abnormal, please replace it. 3. Turn the key switch to the ACC position. 4. Measure the voltage between the terminals of the connector (2) (harness side). 5. When the measurements are the below table value. The ECU is normal. The speed sensor (1) is failure, then please replace it. 6. When the measurements are out of the below table value. The ECU is failure, then please replace it.
(1) Speed Sensor (2) Speed Sensor Connector (Harness Side) (3) Terminal 3 (+) (4) Terminal 2 (Signal) (5) Terminal 1 (GND) W1058552 Water Temperature Sensor 1. Disconnect the water temperature sensor connector (2) (2P). 2. Check the state of the harness and if it is abnormal, please replace it. 3. Turn the key switch to the ACC position. 4. Measure the voltage between the terminals of the connector (2) (harness side). 5. When the measurements are the below table value. The ECU is normal. The water temperature sensor (1) is failure, then please replace it. 6. When the measurements are out of the below table value. The ECU is failure, then please replace it.
(1) Water Temperature Sensor (2) Water Temperature Sensor Connector (Harness Side) (3) Terminal 2 ( ) (4) Terminal 1 (+) W1059499 S-41 KiSC issued 07, 2008 A Voltage Terminal 1 - Terminal 3 12 V Terminal 1 - Terminal 2 5 V Voltage Terminal 1 - Terminal 2 5 V